How to set up bit alliances?

Do you need to add bit rings to your Pelham or Pessoa and are a little lost on how to do it?

There are in fact four possibilities for attaching your reins to your bit.

1. On the largest ring at the top (no leverage, effect comparable to a simple bit)
2. On the bottom ring (very high leverage)
3. Use two pairs of reins
4. To the two rings, that is to say, a piece of leather called a wedding ring must be added which allows for an average action.

The Ohlala tutorial explains to you in a few very simple steps how to add them in a few steps:

1. Check that your bit is in the correct orientation, with the ring loops pointing outwards on both sides so as not to injure your horse.
2. Open the loops on each side of the wedding ring
3. Hang the end of the wedding ring on the largest ring
4. Hang the second end on the bottom ring
5. Attach your reins to the loop formed by the alliance
6. Hang your net amount on the highest ring (where the curb chain is positioned)
7. Repeat the operation on the other side

Products presented:

• Jump'In double-jointed Pelham bit: shop here
• Eric Thomas bit alliances: shop here